HomeMy WebLinkAbout2015-10-13 CDi Prelim PUD - Revised sheets 76The Cannery District - Preliminary
PUD Application
Cannery District Partners
Page 76
Relaxation 10: Building frontage applied in sign
area calculations
Table 38.28.060 - Signage calculations are based on
linear foot of building frontage to a public street.
Lots at buildings E, F, G, H, L, M, and O do not
front a public street. There is no provision
under the Unified Developement Code
for determining allowed signage areas for
buildings with this condition. This proposed
relaxation assigns the following building
signage areas to these buildings.
Building E: 300sf
Building F: 260sf
Building G: 300sf
Building H: 64sf
Building L: 260sf
Building M: 200sf
Building 0: 200sf
The building D lot of Northside PUD does not
front a public street. There is no provision
under the Unified Developement Code
for determining allowed signage areas for
buildings with this condition. This proposed
relaxation assigns the following building
signage area to this building.
Building D: 200sf
Relaxation 11: Building height
Section 38.10.060.A.2 - In the B-2 district: a building
with a roof pitch of less that 3:12 is allowed to be 38
feet in height. This maximum height is allowed to be
increased by 50 percent when a B-2 zoning district is
in a Regional Commercial and Services Growth Policy
land-use designation. The maximum building height
allowed at the Cannery District is therefore 38+19=57
feet.
The existing Cannery Building, Building E, is
59’. In order to address egress deficiencies in
the existing building a new vertical circulation
‘core’ was added to the building. Because of
the required elevator shaft height in relation
to the 4th floor of the existing building, a
portion of the new addition to the Cannery
Building exceeds the height of the existing
building by 2’. This relaxation allows the
Building E only to exceed the max building
height allowed by the Unified Development
Code.Northside PUD