HomeMy WebLinkAboutA1.2 #1 Roof Plans 12-30-2019GENERAL NOTES
1. WRITTEN DIMENSIONS SHALL HAVE PRECEDENCE OVER SCALED DIMENSIONS.
DO NOT SCALE THE DRAWINGS.
2. ALL WORK SHALL COMPLY WITH APPLICABLE CODES LISTED.
3. ALL MATERIALS SHALL BE INSTALLED ACCORDING TO MANUFACTURER'S
RECOMMENDATIONS UNLESS NOTED OTHERWISE. DRAWINGS SHOW THE
DESIGN INTENT AND MAY NOT SHOW ALL DETAILS FOR INSTALLATION.
4. ALL ELECTRICAL AND PLUMBING WORK SHALL BE INSTALLED BY LICENSED
PROFESSIONAL(S) AND SHALL CONFORM WITH CURRENT CODES.
5. CONFIRM AND COORDINATE LOCATIONS OF ALL UTILITIES WITH CONTRACTOR.
6. CONTRACTOR SHALL NOTIFY DESIGNER IMMEDIATELY OF ANY DISCREPANCIES
IN THE DRAWINGS.
7. THE MEANS AND METHODS OF CONSTRUCTION IS THE RESPONSIBILITY OF THE
CONTRACTOR.
8. DIMENSIONS TO FACE OF STUD - TYP.
INFORMATION CONTAINED IN THIS DRAWING SET HAS BEEN PREPARED FOR THE
USE OF A PROFESSIONAL, LICENSED CONTRACTOR WHO IS FAMILIAR WITH
BUILDING CODE AND OTHER LEGAL REQUIREMENTS WITHIN THE PROJECT'S
JURISDICTION. NO WARRANTIES, EXPRESSED OR IMPLIED, ARE GIVEN OR
INTENDED BY THE PREPARATION OF THESE DRAWINGS.
IF THE CLIENT OMITTED CONSTRUCTION PHASE SERVICES AS PART OF THEIR
AGREEMENT WITH A118, THE CLIENT SHALL BE SOLELY RESPONSIBLE FOR
INTERPRETING ALL DOCUMENTS AND OBSERVING THE WORK TO DISCOVER,
CORRECT, OR MITIGATE ERRORS, INCONSISTENCIES, OR OMISSIONS. IF THE
CLIENT AUTHORIZES DEVIATIONS, RECORDED OR UNRECORDED FROM THE
DOCUMENTS, THE CLIENT SHALL NOT BRING ANY CLAIM AGAINST A118 AND SHALL
INDEMNIFY AND HOLD A118 HARMLESS.
ADOPTED CODES:
2012 INTERNATIONAL RESIDENTIAL CODE 2012 UNIFORM PLUMBING CODE
2012 INTERNATIONAL MECHANICAL CODE 2014 NATIONAL ELECTRIC CODE
2012 INTERNATIONAL FUEL GAS CODE 2012 INTERNATIONAL ENERGY
CONSERVATION CODE (IECC)
CONSTRUCTION NOTES
1. ALL LUMBER IN CONTACT w/ CONCRETE or MASONRY or WITHIN 8" OF GRADE SHALL
BE PRESSURE TREATED.
2. FIRE BLOCKING TO BE INSTALLED IN ALL WALL CAVITIES GREATER THAN 10 FEET
TALL AND AS APPLICABLE PER CODE REQUIREMENTS (R602.8).
3. PROVIDE BLOCKING AS NEEDED FOR ALL WALL MOUNTED EQUIPMENT,
FURNISHINGS, ETC.
4. CONFIRM STARTING POINT OF FLOOR FRAMING TO REDUCE CONFLICTS WITH
PLUMBING- FRAMING CONTRACTOR TO VERIFY.
5. CONTRACTOR SHALL VERIFY FLOOR JOISTS FOR DESIRED FLOOR STIFFNESS, TYP.
6. GARAGE SHALL HAVE 5/8" TYPE 'X' GYP BD AT CEILING AND 1/2" GYP BD AT WALLS,
UNLESS NOTED OTHERWISE.
7. INTERIOR CEILINGS TO RECEIVE 5/8" GYP BD, UNLESS NOTED OTHERWISE.
8. PROVIDE SELF-ADHERING ICE AND WATER PROTECTION MEMBRANE AT ALL EAVES
TO A POINT 24" INSIDE THE EXTERIOR WALL FACE AND 18" ON EA. SIDE OF
VALLEYS PER R905.2.7.
9. WINDOWS IDENTIFIED AS "EGRESS" SHALL HAVE MINIMUM CLEAR WIDTH OF 20",
MINIMUM CLEAR HEIGHT OF 22", AND MINIMUM CLEAR AREA OF 5.7 SQ FT. SILL
HEIGHT TO BE 44" MAXIMUM ABOVE FLOOR.
10. ALL PENETRATIONS GREATER THAN 100 SQ INCHES IN COMMON/SHARED GARAGE
WALL SHALL BE UL1479 LISTED, UNLESS NOTED OTHERWISE.
11. CONCRETE SIDEWALKS TO HAVE TOOLED 3/4" JOINT AT 5' INTERVALS, UNLESS
NOTED OTHERWISE.
12. ATTIC VENTILATION OPENINGS SHALL BE COVERED WITH CORROSION-RESISTANT
METAL MESH WITH 1/8" MINIMUM TO 1/4" MAXIMUM OPENINGS.
13. FURNACE (IF LOCATED IN THE CRAWL SPACE) MUST BE LOCATED WITHIN 20' OF
UNOBSTRUCTED PASSAGEWAY NOT LESS THAN 30" HIGH AND 22" LONG FROM THE
CRAWL SPACE ACCESS PER M1305.4. PROVIDE 27 SQ INCHES COMBUSTION FLUE
TO OUTSIDE, SUSPEND 6" MIN. ABOVE GRADE (ASSUMED 80k BTU/H)
14. ALL GLAZING WITHIN A DOOR PANEL, WITHIN 24" OF A SWINGING DOOR, IN WALLS
CONTAINING SHOWERS AND BATHTUBS, WHERE AN INDIVIDUAL PANE IS LARGER
THAN 9 SQUARE FEET, AND ANY GLAZING WHERE THE BOTTOM EDGE IS LESS
THAN 18" ABOVE THE ADJACENT WALKING SURFACE SHALL BE SAFETY GLAZING.
15. SPRAY FOAM INSULATION SHALL BE PROTECTED IN ACCORDANCE w/ R316
16. FIELD CONDITIONS MAY DIFFER THAN WHAT IS ON THE PLANS. IF A DISCREPANCY
ARISES DURING CONSTRUCTION NOTIFY THE DESIGNER IMMEDIATELY SO A
SOLUTION CAN BE MADE WITHOUT SLOWING CONSTRUCTION.
17. FLOOR JOISTS SHALL BE LATERALLY SUPPORTED AT EA. END AND ALL
INTERMEDIATE SUPPORTS BY FULL DEPTH BLOCKING OR RIM BOARD PER R502.7
INSULATION REQUIREMENTS
CONTRACTOR SHALL BE RESPONSIBLE FOR INSULATING THE RESIDENCE IN
ACCORDANCE WITH THE 2012 INTERNATIONAL ENERGY CONSERVATION CODE (IECC)
INCLUDING MONTANA AMENDMENTS.
APPLICABLE PRESCRIPTIVE PATH REQUIREMENTS:
CEILING:R-49 (UNCOMPRESSED R-38 ALLOWED AT EAVES)
EXTERIOR WALL:R-21 (or R-13 + R-5 CONTINUOUS INSULATION)
BASEMENT WALL:R-19 (or R-15 CONTINUOUS INSULATION) - SEE NOTE A
SLAB PERIMETER:R-10 (or R-15 IF HEATED SLAB)
CRAWLSPACE WALL: R-19 (or R-15 CONTINUOUS INSULATION)
WINDOW / DOOR:U-0.32 (R-3)
NOTE A: RES-CHECK ANALYSIS MAY ALLOW LOWER R-VALUE (R-10 MINIMUM)
1. EXTERIOR WALLS SHALL BE CONSTRUCTED OF 2x6 STUDS @ 16" o.c. WITH
R-21 INSULATION, UNLESS NOTED OTHERWISE. ALL EXTERIOR SHEATHING
TO BE 1/2" NOMINAL CONTINUOUS STRUCTURAL RATED PANEL.
2. INTERIOR WALLS SHALL BE CONSTRUCTED OF 2x4 STUDS @ 16" o.c., UNLESS
NOTED OTHERWISE. PROVIDE 2x6 WALLS AT ALL POCKET DOORS. INTERIOR
WALLS TO RECEIVE 1/2" GYP BD, UNLESS NOTED OTHERWISE.
3. FLOOR JOISTS TO BE 11-7/8" TJI 210 @ 16" o.c. WITH 1-3/4" MIN BEARING,
UNLESS NOTED OTHERWISE
4. FLOOR DECK TO BE 3/4" TONGUE-AND-GROOVE, STRUCTURAL RATED PANEL
(48/24 CDX) UNLESS NOTED OTHERWISE.
5. ALL LUMBER SHALL BE NO. 2 GRADE OR BETTER.
6. ALL HEADERS (6' MAX SPAN) AT EXTERIOR WALLS SHALL BE (2) 2x10 HF#2 OR
BETTER w/ (2) JACK STUDS AT EACH END, UNLESS NOTED OTHERWISE.
7. PROVIDE BLOCKING BETWEEN TRUSSES AT ALL BEARING LOCATIONS.
STRUCTURAL NOTES
3 | A2.1
1 | A2.1
2 | A2.1
4 | A2.1
3 "
/
1 2 "
5 "
/
1 2 "
5 "
/1 2 "
3 "
/
1 2 "
3 "
/
1 2 "
12" /12"12" /12"
4" /12"4" /12"
4" /12"
3 "
/
1 2 "
RIDGE VENT
GUTTER
GUTTER
GUTTER
GUTTER
G U T T E R
G U T T E R
GUTTER
5 "
/1 2 "
5 "
/1 2 "
1' - 6"
1 '
-
6 "
2 '
-
0 "
1' - 0"
10' -8"
1' - 0"1' - 0"1' - 6"
1 '
-
6 "
1' - 6"
ALIGN OVERHANGS
1 '
-
6 "
1' - 6"
1 '
-
6 "
1' - 6"
1' - 0"
1 '
-
6 "
1' - 0"
R I D G E V E N T
PHASE:PROJECT #:
DRAWN BY:
DRAWING NUMBER:
DRAWING TITLE:
architecture one eighteen
115 east oak street bozeman mt 59715
CHECKED BY:
REVISIONS:
COPYRIGHT NOTICE: This document
and the ideas and designs incorporated
herein are given in confidence and shall
be used only pursuant to the agreement
with Architecture118. No other use,
dissemination, or duplication may be
made without prior written consent of
Architecture118. All common law rights
of copyright are hereby specifically
reserved.
OWNER:
0 "
1 "
2 "
DEC. 10, 2019
18-016
RER STH
95% SET
A1.2
ROOF PLAN
M
O
U
N
T
A
I
N
V
I
S
T
A
P
L
A
N
#
1
2
9
2
8
W
E
S
T
B
A
B
C
O
C
K
S
T
.
S
1
1
,
T
0
2
S
,
R
O
5
E
,
T
R
A
C
T
2
4
B
O
Z
E
M
A
N
M
T
McINTOSH
CONSTRUCTION
406.580.2668
123 DESCRIPTION 09/09/09
1/4" = 1'-0"2 ROOF PLAN